System
does not work automatically |
1.
Circuit breaker may be tripped
2. Reservoir may be low or empty |
1. Check
your breaker
2. Refill with Py-Tech (Pyrethrum Insecticide)
|
Motor
labors during operation (cuts on/off) |
1.
Operating pressure set too high
2. Suction filter may be clogged
|
1.
Adjust pressure (150-160 psi).
Never set above 175 psi
2. Clean or replace suction filter
|
All
nozzles drip or spew during startup & shutdown
(there is a delay between when the motor turns
on and nozzles spray) |
1. Air
in tubing line to nozzles
2. Used a strong chemical that has
damaged system O-Rings |
1. Bleed air. If problem persists call
for help 1-800-776-5005
2. Use only Py-Tech
|
Spray
system does not register ample pressure (150
psi) |
1.
Suction filter may be clogged
2. Check valve may be clogged
3. Pump may be damaged
4. Pressure gauge may be faulty
|
1. Clean
or replace
2. Clean or replace
3. Replace pump
4. Replace gauge
|
Some
nozzles do not spray as good as others0 |
1.
Nozzle filters or internal parts may be clogged |
1. Clean
or replace spray tip only
|
NOTE:
Pro-Tech’s
insecticide and odor control solutions
are specially formulated for Pro-Tech’s
spraying systems with safety and
performance in mind. They will not
damage the seals and o-rings found
throughout the pump, valves and spray
nozzles. Nor will they separate out of
solution in the reservoir and tubing.
Therefore, you will receive optimum
performance with no nozzle clog. Using
solutions other than Pro-Tech’s voids
your warranty. |
|